Good Habit #3: Combine your commands with control operators

You probably already know that in most shells, you can combine commands on a single command line by placing a semicolon (;) between them. The semicolon is a shell control operator, and while it is useful for stringing together multiple discrete commands on a single command line, it does not work for everything. For example, suppose you use a semicolon to combine two commands in which the proper execution of the second command depends entirely upon the successful completion of the first. If the first command does not exit as you expected, the second command still runs -- and fails. Instead, use more appropriate control operators (some are described in this article). As long as your shell supports them, they are worth getting into the habit of using them.

Run a command only if another command returns a zero exit status

Use the && control operator to combine two commands so that the second is run only if the first command returns a zero exit status. In other words, if the first command runs successfully, the second command runs. If the first command fails, the second command does not run at all. For example:

Listing 1. Example of good habit #3: Combining commands with control operators

~ $ cd tmp/a/b/c && tar xvf ~/archive.tar

In this example, the contents of the archive are extracted into the ~/tmp/a/b/c directory unless that directory does not exist. If the directory does not exist, the tar command does not run, so nothing is extracted.

Run a command only if another command returns a non-zero exit status

Similarly, the || control operator separates two commands and runs the second command only if the first command returns a non-zero exit status. In other words, if the first command is successful, the second command does not run. If the first command fails, the second command does run. This operator is often used when testing for whether a given directory exists and, if not, it creates one:

Listing 2. Another example of good habit #3: Combining commands with control operators

~ $ cd tmp/a/b/c || mkdir -p tmp/a/b/c

You can also combine the control operators described in this section. Each works on the last command run:

Listing 3. A combined example of good habit #3: Combining commands with control operators

~ $ cd tmp/a/b/c || mkdir -p tmp/a/b/c && tar xvf -C tmp/a/b/c ~/archive.tar